Job Summary

Application Requirements (Essential)

・At least 5 years’ practical experience in testing and evaluation of automotive components or thermal management equipment

・Experience in establishing test plans, measurement methods and pass/fail criteria based on required specifications

・Experience in measuring temperature, flow rate, pressure, voltage and current, and in data analysis

・Experience in reviewing specifications for evaluation equipment and fixtures, or in setting up measurement environments

・Experience in analysing the causes of faults and implementing improvements in collaboration with the design department

・Experience in performance and reliability evaluation during mass production development

Key Responsibilities

Main Scope of Duties

・Formulation of evaluation plans based on ECH/ECCH requirements, and the establishment of measurement methods and pass/fail criteria corresponding to each requirement

・Setting of measurement points for temperature, flow rate, pressure, voltage and current, and the construction of evaluation benches, jigs and measurement environments

・Planning, conducting and analysing the results of tests on heating performance, pressure loss, leakage, insulation resistance, dielectric strength, vibration and thermal cycling, amongst others

・Evaluation of behaviour under abnormal conditions such as low flow rate, flow stoppage, flow path blockage, air entrainment and pump stoppage

・Assessment of the validity of temperature sensor placement, responsiveness, overheating detection time and protective actions

・Analysis of discrepancies between simulation results and actual measurement data, and submission of improvement proposals to the design and analysis teams

・Safety verification against unintended heating, failure to cease heating, overheating at low flow rates, sensor faults, control circuit failures, etc.

・Fault injection tests in collaboration with the system and control teams, and verification of anomaly detection and shutdown operations

・Preparation of evaluation reports and management of evaluation issues in preparation for mass production launch

Skill Requirements

Desirable Qualifications

・Experience in evaluating insulation resistance and dielectric strength for high-voltage products

・Experience in comparing and verifying thermal-fluid analysis results against actual measurement results

・Experience in vibration, thermal cycling and endurance testing

・Experience in functional safety verification and fault injection testing

・Experience in product evaluation using LIN/CAN

・Experience in automating measurement and data processing

・Experience in evaluating thermal management components such as ECH and ECCH

Other Requirements